RAYDENT C&B
Tips for better accuracy per restoration type
Preparation
Temperature | Check if the temperature of the sticker thermometer is higher than 18 degrees Check if the temperature sensor indicates it's higher than 18 degrees |
Build plate status | Check if there's previous printout Check if build plate is firmly locked |
Vat | Check if there's subjected resin to be printed Check if there's enough quantity of resin to print Mix up for 10 secs with spatula before daily the first print |
Resin mixing guide |
Bottle: 5 mins Pouch: 1 min |
1. Single crown
1. Rotate to have the surface angle to be 0˚~45˚(fig.)
2. It might have tight fit, if you rotate the crown horizontally to protect occlusal surface
3. Remove only black supports if there's too many supports
2. Bridge
1. Rotate to have the surface angle to be vertical (fig.)
2. It might have tight fit, if you rotate the crown horizontally to protect occlusal surface
3. Full-arch
1. Rotate to have the surface angle to be vertical (fig.)
2. It might have tight fit, if you rotate the crown horizontally to protect occlusal surface
3. Remove only black supports if there's too many supports
4. SCRP
1. Rotate to have the surface angle to be vertical (fig.)
2. It might have tight fit, if you rotate the crown horizontally to protect occlusal surface
3. Remove only black supports if there's too many supports
4. Remove black supports around the screw hole