RAYDENT SG
Tips for better accuracy per restoration type
Preparation
Temperature | Check if the temperature of the sticker thermometer is higher than 18 degrees Check if the temperature sensor indicates it's higher than 18 degrees |
Build plate status | Check if there's previous printout Check if build plate is firmly locked |
Vat | Check if there's subjected resin to be printed Check if there's enough quantity of resin to print Mix up for 10 secs with spatula before daily the first print |
Resin mixing guide |
Bottle: 5 mins / Pouch: 1 min |
1. When S.G has same insertion axis of drill holes.
1. Rotate to have inner surface faces upward (fig.)
2. Adjust drill hole's insertion axis to be vertical
3. It might have tight fit, if you rotate the whole surgical guide vertically
to protect sleeve hole
4. Remove only black supports if there's too many supports
2. When S.G has multiple different insertion axis of drill holes.
1. Rotate to have inner surface faces upward (fig.)
2. Look for the area that has the most similar insertion axis
3. Adjust drill hole's insertion axis to be vertical
4. It might have tight fit, if you rotate the whole surgical guide vertically
to protect sleeve hole
5. Remove only black supports if there's too many supports
※ TIP
1. If necessary, grind off supports around the sleeve holes after print (fig.)
2. With this angle, the anchor hole could be tight
But it's not tight as much as the anchor pin's thread can't grind inside and be placed